Our range of products
Contacts
About us

 

Using the right wax is important , but it is as much important to apply it in the right manner and take care with attention the cleaning of the chests to which it is assigned...



 
Waxing cloths and Cleaning cloths

Waxing cloths
The secret in the use of wax is not only its quality , but also the way in which it gets applied . The wax must melt totally on the chests and not be absorbed.
by the felts. In order to ensure that this happens, it is necessary the use of a waxing cloth,  produced purposely to prevent the felt from coming in contact
with the wax the moment in which it melts and at the same time let it distribute rationally all over the surface of all ironer’s chests.
If the felt would absorb wax, a part from having an excessive consumption of the same, you
will be looking at a waterproofing of the felt, at a suction reduction, of productivity and at a reduction of the average life of the felt.

WAXING CLOTH “TC”
Model in cotton with pockets in silicon spread nomex . Available in two sizes (standard and large);  on request we can produce to tailored made dimensions
Cod. BT0101       dim. cm. 190 x 150          standard
Cod. BT0102       dim. cm. 300 x 150          large

TREVIRA WAXING CLOTH
Model in trevira with pockets in silicon spread nomex. Model for steam ironers. Available in two sizes (standard and large); on request we can produce to tailored made dimensions
Cod. BT0103       dim. cm. 190 x 150          standard
Cod. BT0104       dim. cm. 300 x 150          large

 

Cleaning cloths    
Lubricating is not enough to keep a chest in good order, it needs also cleaning it.  It is good practice to exercise a cleaning action whenever necessary and in any case every day  before switching off the ironer.
Passing through an abrasive cleaning cloth daily over still warm surfaces , allows to remove all those residuals which get deposited during the day , before the cooling phase get them crystallized. The residuals could be of any kind: brought by the hardness of the water, detergent residuals, bad waxing residuals  ecc..
It does not exist an ironer which is immune to residuals.
To reduce to the minimum the friction brought by these impurities, cleaning at the end of a shift is almost an obligation.

CLEANING CLOTH C.L. SPECIAL
It has been planned and produced to allow the removal also of those impurities not visible to the naked eye. Provided of abrasive textile.
Cod. BT0103       dim. cm. 190 x 150          standard

CLEANING CLOTH VENTILATO
Planned and produced to allow also the removals of those impurities not visible to the naked eye in an abrasive cleaning material of particular characteristics
Cod. BT15           dim. cm. 185 x 128          standard

 

 

NUOVA FOLATI - Laundry Quality Solutions